Transient Isosurfaces
Next look at the already defined isosurfaces in the project:
-
Switch the Simulation assigned to the 100% LFL isosurface to the HP Release 01 on Westerly, 5 m/s with the transient data. If you are unfamiliar with this process, Tutorial 5 goes over changing simulations synced with already defined visualizations.
-
Similar to the options for selecting a time step for the contour, you can choose the Simulation time of the isosurface.
Tutorial 8 - Figure 07 - selection of the time step for an already defined isosurface in the project after change the simulation the isosurface is displaying
-
Select the second option listed in the Simulation Time, for the figure above this is at 0.0317 seconds.
-
The isosurface will be updated and show appear similar to the figure below.
Tutorial 8 - Figure 08 - 100%LFL isosurface at 0.03s from start
-
Repeat steps 1 through 4 for the 50 %LFL isosurface. We can see that at the initial stages of the leak the 50% and 100% LFL values are nearly identical. Take some time and repeat Step 3 to compare the isosurfaces at other time steps.
Tutorial 8 - Figure 09 - 50%LFL (blue) and 100%LFL (red) isosurface at 0.03s from start
Continue to the next section to review the monitor point data for the transient simulation.